AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Arduino nano pinout spi3/21/2023 The Nano has 8 analog inputs, each of which provide 10 bits of resolution (i.e. When the pin is HIGH value, the LED is on, when the pin is LOW, it's off. There is a built-in LED connected to digital pin 13. These pins support SPI communication, which, although provided by the underlying hardware, is not currently included in the DFRduino language. Provide 8-bit PWM output with the analogWrite() function. See the attachInterrupt() function for details. These pins can be configured to trigger an interrupt on a low value, a rising or falling edge, or a change in value. These pins are connected to the corresponding pins of the FTDI USB-to-TTL Serial chip.Įxternal Interrupts: 2 and 3. Used to receive (RX) and transmit (TX) TTL serial data. In addition, some pins have specialized functions: Each pin can provide or receive a maximum of 40 mA and has an internal pull-up resistor (disconnected by default) of 20-50 kOhms. Input and OutputĮach of the 14 digital pins on the Nano can be used as an input or output, using pinMode(), digitalWrite(), and digitalRead() functions. The ATmega168 has 1 KB of SRAM and 512 bytes of EEPROM (which can be read and written with the EEPROM library) the ATmega328 has 2 KB of SRAM and 1 KB of EEPROM. The DFRduino Duemilanove 168 (SKU:DFR0002) has 16 KB of flash memory for storing code (of which 2 KB is used for the bootloader) the ATmega328 has 32 KB, (also with 2 KB used for the bootloader). As a result, when running on external (non-USB) power, the 3.3V output (which is supplied by the FTDI chip) is not available and the RX and TX LEDs will flicker if digital pins 0 or 1 are high. The FTDI FT232RL chip on the Nano is only powered if the board is being powered over USB. The power source is automatically selected to the highest voltage source. The DFRduino Nano can be powered via the Micro USB connection, 6-20V unregulated external power supply (pin 30), or 5V regulated external power supply (pin 27). EEPROM 512 bytes (ATmega168) or 1 KB (ATmega328).SRAM 1 KB (ATmega168) or 2 KB (ATmega328).Flash Memory 16 KB (ATmega168) or 32 KB (ATmega328) of which 2 KB used by bootloader.Digital I/O Pins 14 (of which 6 provide PWM output).Microcontroller Atmel ATmega168 or ATmega328.The DFRobot DFRduino Nano USB Microcontroller V3 (ATMega 328) can be powered via the mini-B USB connection, 6-20V unregulated external power supply (pin 30), or 5V regulated external power supply (pin 27). The nano's pin layout works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one side, power and ground on the other). The Nano automatically senses and switches to the higher power supply, so there is no need for a power select jumper. The Nano has everything that the Diecimila has (electronically) with more analog input pins and an on-board +5V AREF jumper. The DFRduino Nano USB Microcontroller V3 (ATMega 328) is a breadboard ready version of the Arduino mini with integrated USB.
0 Comments
Read More
Leave a Reply. |